LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Latch Release Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cable End & Hood Release Handle
    GM833078Courtesy of GENERAL MOTORS CORP.
  1. From the driver side compartment area, route the cable through the access hole in the cowl (2).
  2. Attach the retainer clips that retain the hood release cable to the cowl.
  3. Connect the cable end (1) to the hood release latch.
  4. Set the hood release handle in place.
    5. NOTE: Refer to Fastener Notice .
  5. Install the fastener retaining handle to the vehicle.

    Tighten:  Tighten the fasteners to 9 N.m (7 lb ft).

  6. Install the driver side kick up panel. Refer to Front Floor Kick-Up Panel Replacement .
scientia non olet · About LEMON Manuals