LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Hinge Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Hood Hinge Bolts
    GM820616Courtesy of GENERAL MOTORS CORP.
  1. With the hood properly supported, position the hinge to the front bumper support.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts (2) retaining the hinge to the front bumper support.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the nuts (1) retaining the hinge to the hood.

    Tighten:  Tighten the nuts to 18 N.m (13 lb ft).

  4. Adjust the hood, if necessary.
scientia non olet · About LEMON Manuals