LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Adjustment

Hood Adjustment

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Hood Adjuster
    GM839884Courtesy of GENERAL MOTORS CORP.
  1. Adjust the hood by turning the hood adjuster (1) clockwise to lower the hood, and counterclockwise to raise the hood.
    2. Fig 2: Locating Hood Adjusters & Hood To Fender Gap
    GM839886Courtesy of GENERAL MOTORS CORP.
  2. Adjust the hood until a gap of approximately 1/4 inch is reached at the hood to fender gap (2) and the hood to non functional air inlet (1) gap. Ensure that the gaps are equal from side to side.
  3. After the adjustment is complete, adjust the hood latch.
    4. NOTE: Refer to Fastener Notice .
  4. Adjust the hood latch by loosening the hood latch bolts (1) and moving the latch upward and downward, inward and outward, until the hood latch latches properly and securely retains the hood.

    Tighten:  Tighten the hood latch bolts to 9 N.m (7 lb ft).

scientia non olet · About LEMON Manuals