LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Fuel Tank Filler Pipe Housing Replacement (BASE) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Pocket Components
    GM1453823Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel filler cap (2) and disengage the tether clip (3) from the pocket (1).
    2. Fig 2: Fillerneck Components
    GM1453825Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws (1) securing the pocket to the filler neck (3).
    3. Fig 3: Fuel Pocket
    GM1453824Courtesy of GENERAL MOTORS CORP.
  3. With the screws removed, rotate the pocket (1) 1/8 turn counterclockwise in order to release the pocket from the body quarter panel.
  4. Remove the filler pocket from the vehicle.
scientia non olet · About LEMON Manuals