LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front and Rear Side Door Upper Auxiliary Weatherstrip Replacement (SUT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Luggage Carrier Side Rail, Weatherstrip, Auxiliary Weatherstrip
    GM1486507Courtesy of GENERAL MOTORS CORP.
  1. Starting at the center of the door openings, install the weatherstrip (2) to bottom edge of the luggage carrier side rail (1) and work across the right and left sides towards the ends of the weatherstrip, being careful not to stretch the weatherstrip during installation.
  2. Ensure the rear edge (2) of the upper auxiliary weatherstrip overlaps the top edge of the rear side door - rear auxiliary weatherstrip (3).
  3. Use a roller-type tool to ensure the weatherstrip is fully seated.
  4. Close the doors.
scientia non olet · About LEMON Manuals