LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Side Door Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove water deflector. Refer to Front Side Door Water Deflector Replacement .
  3. Disconnect the speaker electrical connector.
  4. Disconnect the door lock actuator electrical connector.
  5. Disconnect the power mirror electrical connector.
    6. Fig 1: Locating Front Door Wiring Harness
    GM838822Courtesy of GENERAL MOTORS CORP.
  6. Remove the wiring harness from the door through the pass-through hole (1) by releasing all retainers and noting their location for reinstallation.
  7. Disconnect the wiring harness from the body harness.
scientia non olet · About LEMON Manuals