LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Side Door Wiring Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the wiring harness to the body harness.
    2. Fig 1: Locating Front Door Wiring Harness
    GM838822Courtesy of GENERAL MOTORS CORP.
  2. Route the wiring harness through the pass-through hole (1), ensuring that the rubber grommet seal is fully seated.
  3. Fasten the wiring harness to the door by attaching all retainers in their proper location.
  4. Connect the power mirror electrical connector.
  5. Connect the door lock actuator electrical connector.
  6. Connect the window motor electrical connector.
  7. Connect the speaker electrical connector.
  8. Operate all electrical door components to ensure proper operation.
  9. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  10. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals