LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Side Door Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Front Door Fastener
    GM901566Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. With an assistant, align the door to the vehicle and install the fastener (1) that retains the door hinge halves together.

    Tighten:  Tighten the fastener to 9 N.m (7 lb ft).

  2. Transfer components as necessary.
  3. Install the fasteners that retain the door check link to the body. Refer to Door Check Link Replacement .
  4. Install the wiring harness. Refer to Front Side Door Wiring Harness Replacement .
  5. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  6. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .