LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Front Door Opening Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Door Opening Weatherstrip
    GM862061Courtesy of GENERAL MOTORS CORP.
  1. Starting at the top center of the door opening, install the weatherstrip (2) to the pinch-weld flange (1) and work down the right and left sides towards the bottom center, being careful not to stretch the weatherstrip during installation.
  2. Use a rubber mallet to ensure proper seating of the weatherstrip on the pinch-weld flange.
  3. Close the door.
scientia non olet · About LEMON Manuals