LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Folding Rear Panel Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Midgate Wiring Harness
    GM1412515Courtesy of GENERAL MOTORS CORP.
  1. Position the midgate electrical harness to the midgate structure.
  2. Secure the midgate electrical harness grommet to the midgate structure.
  3. Connect the midgate harness connector to the main body harness.
  4. Secure the midgate harness grommet.
  5. Secure the midgate wire harness retainers to the midgate structure.
  6. Install the midgate latches. Refer to Midgate Latch Replacement .
  7. Install the midgate window regulator. Refer to Midgate Window Regulator Replacement .
  8. Install the midgate window. Refer to Midgate Window Replacement .
    9. Fig 2: View Of Midgate Components
    GM1427695Courtesy of GENERAL MOTORS CORP.
  9. Install the lower interior center molding (4). Refer to Endgate Center Molding Replacement .
  10. Install the midgate inner panel. Refer to Midgate Inner Panel Replacement .
scientia non olet · About LEMON Manuals