LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Endgate Weatherstrip Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Swing the tire carrier fully outward.
  2. Open the endgate.
    3. Fig 1: Endgate Opening Pinch-Weld Weatherstrip
    GM1412531Courtesy of GENERAL MOTORS CORP.
  3. Remove the weatherstrip from the endgate opening pinch-weld flange.
scientia non olet · About LEMON Manuals