LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Endgate Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Endgate Opening Pinch-Weld Weatherstrip
    GM1412531Courtesy of GENERAL MOTORS CORP.
  1. Position the weatherstrip to one side of the pinch-weld flange at the underside of the cargo box rail protector.
  2. Press the weatherstrip onto the pinch-weld flange and under the cargo floor liner.
  3. Ensure the weatherstrip is securely attached to the opposite side under the cargo box rail protector.
  4. Close the endgate.
  5. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals