LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Endgate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the spare tire carrier.
  2. Open the endgate to a 45-degree angle.
    3. Fig 1: Endgate Support Cable
    GM1486510Courtesy of GENERAL MOTORS CORP.
  3. Release both right and left hand cables from the side panel cable bolts.
    4. Fig 2: View Of Bolts & Endgate Trunnion
    GM1428255Courtesy of GENERAL MOTORS CORP.
  4. Lift the right side endgate off the endgate trunnion (2).
  5. Remove the left side of the endgate off the left side trunnion.
  6. Place the endgate on a clean, dry surface.
    7. Fig 3: Latch And Related Components
    GM1428254Courtesy of GENERAL MOTORS CORP.
  7. Remove the following parts:
    • Lower trunnion
    • Endgate latch assembly (2)
    • Endgate handle bezel
    • Endgate handle/lock rods
    • Endgate cap
    • Endgate liner
scientia non olet · About LEMON Manuals