LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Endgate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Latch And Related Components
    GM1428254Courtesy of GENERAL MOTORS CORP.
  1. Install the following parts:
    • Endgate liner
    • Endgate cap
    • Endgate handle/lock rods
    • Endgate handle bezel
    • Endgate latch assembly (2)
    • Both lower trunnions
  2. Position the left side of the endgate to the lower left trunnion.
    3. Fig 2: View Of Bolts & Endgate Trunnion
    GM1428255Courtesy of GENERAL MOTORS CORP.
  3. At a 45-degree angle, set the right side onto the right lower trunnion (2).
    4. Fig 3: Endgate Support Cable
    GM1486510Courtesy of GENERAL MOTORS CORP.
  4. Secure both cables to the side panel cable bolts.
  5. Close the endgate.
  6. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals