LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Endgate Lower Hinge Replacement - Endgate Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hinge Trunnion Bolts
    GM1412527Courtesy of GENERAL MOTORS CORP.
  1. Install the hinge trunnion to the endgate.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts retaining the hinge to the endgate.

    Tighten: 

    1. Tighten the lower forward bolt (2) to 25 N.m (19 lb ft).
    2. Tighten the lower rear bolt (1) to 25 N.m (19 lb ft).

    3. Fig 2: Remove/Install Endgate From Vehicle
    GM1412520Courtesy of GENERAL MOTORS CORP.
  3. Install the endgate to the vehicle. Refer to Endgate Replacement .
scientia non olet · About LEMON Manuals