Endgate Adjustment

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Adjusting Endgate Hinge Bolts

Courtesy of GENERAL MOTORS CORP.

To adjust the liftgate upward or downward, slightly loosen the bolts retaining the liftgate to the hinge (1).

Fig 2: Adjusting Liftgate To Rear Bumper Fascia

Courtesy of GENERAL MOTORS CORP.

Adjust the liftgate (1) to the rear bumper fascia (2) gap (A) to 22-24 mm (0.86 in-0.94 in).

Fig 3: Adjusting Endgate Hinge Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Tighten the bolts (1) retaining the liftgate to the hinge.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).

Fig 4: Adjusting Endgate Hinge Bolts

Courtesy of GENERAL MOTORS CORP.

To adjust the liftgate inward or outward, remove the rear upper garnish molding trim. Refer to Rear Upper Garnish Molding Replacement .
Slightly loosen the bolts retaining the hinge to the vehicle.

Fig 5: Adjusting Endgate Hinge Bolts

Courtesy of GENERAL MOTORS CORP.

Adjust the liftgate (1) to roof (2) gap (A) to 13 mm (0.51 in).
Tighten the bolts (1) retaining the hinge to the vehicle.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).
Install the rear upper garnish molding trim. Refer to Rear Upper Garnish Molding Replacement .
Operate the liftgate to inspect for proper operation.