Conditions for Running the DTC

DTCs P0030, P0036, P0050, P0053, P0059, P0101, P0102, P0103, P0106, P0107, P0108, P0117, P0118, P0128, P0131, P0132, P0133, P0134, P0135, P0151, P0152, P0153, P0154, P0155, P0201-P0206, P0300, P0301-P0306, P0411, P0412, P0418, P0442, P0443, P0446, P0449, P0452, P0453, P0454, P0455, P0496, P1133, P1153, P1516, P2101, P2119, P2120, P2125, P2135, P2138, P2176, P2431, P2432, P2433, P2440, P2A00, P2A03 are not set.
The device control is not active.
The intrusive diagnostics are not active.
The engine overspeed protection is not active.
The power take-off (PTO) is not active.
The traction control is not active.
The fuel control is in air-fuel Closed Loop.
The system voltage is less than 10 volts, or greater than 18 volts.
The engine run time is greater than 100 seconds.
The engine coolant temperature (ECT) is greater than -20°C (-4°F).
The engine speed is greater than 425 RPM, but less than 6,000 RPM.
The mass air flow is greater than 25 g/s, but less than 510 g/s.