LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 6.2L - DTC P0010 To DTC P0232 >> DTC P0201, P0202, P0203, P0204, P0205, P0206, P0207, or P0208 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the affected fuel injector harness connector at the fuel injector.
  2. Ignition ON, verify that a test lamp illuminates between the ignition 1 voltage circuit terminal A and ground.
    • If the test lamp does not illuminate, test the ignition 1 voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal and the ignition 1 voltage circuit fuse is open, test or replace the fuel injector.
  3. Connect the J 34730-405  between the control circuit terminal B and the ignition 1 voltage circuit terminal A. See Special Tools .
  4. Command the fuel injector ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the ECM.
    • If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the fuel injector.
scientia non olet · About LEMON Manuals