LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Controls And Fuel - 6.2L - Introduction (2 Of 2) >> Repair Instructions >> Evaporative Emission Canister Vent Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

    Fig 1: EVAP Vent Pipe & Mounting Clips
    GM627206Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the EVAP vent valve and the EVAP canister.
  2. Connect the EVAP vent pipe (2) to the EVAP vent valve.
  3. Connect the EVAP vent pipe to the EVAP canister.
  4. Install the EVAP vent pipe into the mounting clips (1,3,4, and 5).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals