LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling >> Repair Instructions >> Radiator Surge Tank Inlet Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Surge Tank Hose & Radiator
    GM801111Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill)  or Cooling System Draining and Filling (Vac-N-Fill) .
  2. Reposition the surge tank inlet hose clamp from the radiator.
  3. Remove the surge tank inlet hose (1) from the radiator.
    4. Fig 2: Surge Tank Components
    GM801110Courtesy of GENERAL MOTORS CORP.
  4. Reposition the surge tank inlet hose clamp (1) at the surge tank (2).
  5. Remove the surge tank inlet hose (6) from the surge tank (2).
scientia non olet · About LEMON Manuals