LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling >> Repair Instructions >> Radiator Surge Tank Inlet Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Surge Tank Components
    GM801110Courtesy of GENERAL MOTORS CORP.
  1. Install the surge tank inlet hose (6) to the surge tank (2).
  2. Position the surge tank inlet hose clamp (1) to the surge tank (2).
    3. Fig 2: Surge Tank Hose & Radiator
    GM801111Courtesy of GENERAL MOTORS CORP.
  3. Install the surge tank inlet hose (1) to the radiator.
  4. Position the surge tank inlet hose clamp to the radiator.
  5. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill)  or Cooling System Draining and Filling (Vac-N-Fill) .
scientia non olet · About LEMON Manuals