LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling >> Repair Instructions >> Engine Oil Cooler Hose/Pipe Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Oil Cooler Hoses
    GM721990Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine oil cooler hoses from the radiator. Refer to Engine Oil Cooler Pipe/Hose Quick Connect Fitting .
  2. Remove the engine oil cooler hoses from the fan shroud.
  3. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the engine protection shield bolts.
  5. Remove the engine shield.
    6. Fig 2: View Of Oil Cooler Hose Bracket Bolt & Adapter Bolts
    GM688324Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine oil cooler hose bracket bolt (1).
  7. Remove the engine oil cooler hose adapter bolts (2).
  8. Remove the engine oil cooler hose assembly and gasket.

    Discard the gasket.

  9. Inspect the fittings, connectors and cooler hoses for damage or distortion.
scientia non olet · About LEMON Manuals