LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling >> Repair Instructions >> Engine Oil Cooler Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Oil Cooler Hose Bracket Bolt & Adapter Bolts
    GM688324Courtesy of GENERAL MOTORS CORP.
  1. Install the engine oil cooler hose assembly and a new gasket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the engine oil cooler hose adapter bolts (2).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  3. Install the engine oil cooler hose bracket bolt (1).

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  4. Install the engine protection shield.
  5. Install the engine shield bolts.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

    6. Fig 2: View Of Oil Cooler Hoses
    GM721990Courtesy of GENERAL MOTORS CORP.
  6. Install the engine oil cooler hoses to the fan shroud.
  7. Install the engine oil cooler hoses to the radiator. Refer to Engine Oil Cooler Pipe/Hose Quick Connect Fitting .
scientia non olet · About LEMON Manuals