LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling >> Repair Instructions >> Cooling Fan and Shroud Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Radiator, Inlet & Outlet Hose & Clamps
    GM1486075Courtesy of GENERAL MOTORS CORP.
  1. Disengage the radiator inlet hose clip (2) at the fan shroud.
    2. Fig 2: View Of Surge Tank Inlet Hose & Clamp
    GM1698684Courtesy of GENERAL MOTORS CORP.
  2. If necessary, reposition the surge tank inlet hose clamp at the radiator.
  3. If necessary, remove the surge tank inlet hose from the radiator.
    4. Fig 3: Cooling Fan Electrical Connectors
    GM1480471Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connectors from the cooling fans.
  5. Remove the clip attaching the wiring harness to the shroud.
  6. Remove transmission cooler lines bolts from fan shroud.
    7. Fig 4: Engine Oil Cooler Quick Connect Fittings
    GM1486208Courtesy of GENERAL MOTORS CORP.
  7. If necessary, open the engine oil cooler line clip and remove the cooler lines from the clip.
    8. Fig 5: Cooling Fan Shroud & Bolts
    GM1485882Courtesy of GENERAL MOTORS CORP.
  8. Remove the cooling fan shroud bolts.
  9. Remove the cooling fan and shroud.
scientia non olet · About LEMON Manuals