LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling >> Repair Instructions >> Coolant Air Bleed Pipe Assembly Replacement >> Removal Procedure

Removal Procedure

  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill)  or Cooling System Draining and Filling (Vac-N-Fill) .
  2. Remove the generator. Refer to Generator Replacement .
    3. Fig 1: Identifying Coolant Air Bleed Pipe And Bolts
    GM741555Courtesy of GENERAL MOTORS CORP.
  3. Remove the coolant air bleed pipe bolts (1).
  4. Remove the coolant air bleed pipe (2) with gaskets (3).
    5. Fig 2: View Of Air Bleed Pipe Sealing Gasket
    GM64262Courtesy of GENERAL MOTORS CORP.
  5. Remove the gaskets from the coolant air bleed pipe and covers.
  6. Discard the gaskets.
    7. Fig 3: Coolant Air Bleed Hose & Pipe
    GM790766Courtesy of GENERAL MOTORS CORP.
  7. Remove the coolant air bleed hose (1) from the pipe (2).
scientia non olet · About LEMON Manuals