LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Right Side >> Removal Procedure

Removal Procedure

  1. Remove the right side end panel.
  2. Push in the tabs in order to remove the fuse block.
    3. Fig 1: Right Instrument Panel Electrical Center Or Junction Block
    GM375032Courtesy of GENERAL MOTORS CORP.
  3. Pull out the fuse block out of the I/P in order to remove the retaining bolt.
  4. Loosen the bolt.
  5. Insert a screw driver between the wire harness block and fuse block in order to separate.
  6. Separate the fuse block from the I/P harness block.
  7. Remove the IP wiring harness block from the vehicle.
scientia non olet · About LEMON Manuals