LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Instrument Panel Electrical Center or Junction Block Replacement - Right Side >> Installation Procedure

Installation Procedure

  1. Install the fuse block to the I/P wire harness block.
    2. NOTE: Refer to Fastener Notice .
  2. Install the retaining bolt.

    Tighten:  Tighten the bolt to 6 N.m (53 lb in)

    3. Fig 1: Fuse Block & I/P
    GM375030Courtesy of GENERAL MOTORS CORP.
  3. Install the fuse block to the I/P till it clicks in place.
    4. Fig 2: Right Instrument Panel Electrical Center Or Junction Block
    GM375032Courtesy of GENERAL MOTORS CORP.
  4. Connect the wiring connectors to the fuse block.

    Refer to Electrical Center Identification Views to ensure the right connections are made.

  5. Install the right side end panel.
scientia non olet · About LEMON Manuals