LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Electrical >> Gauges >> Displays And Gages >> Diagnostic Information and Procedures >> Fuel Gage Inaccurate or Inoperative >> Component Testing

Component Testing

  1. Ignition OFF, disconnect the harness connectors at the fuel level sensor.
  2. While sweeping the fuel level sensor through its full range of motion, test for a minimum value less than 41 ohms and a maximum value greater than 119 ohms between the signal terminal B and the low reference terminal C.
    • If not within the specified range, replace the fuel level sensor.
scientia non olet · About LEMON Manuals