LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Electrical >> Gauges >> Displays And Gages >> Diagnostic Information and Procedures >> Engine Oil Pressure Indicator Always On >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector of the EOP sensor.
  2. Ignition OFF, test for less than 1 ohm of resistance between the low reference circuit terminal 1 and ground.
    • If greater than 1 ohm, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal 2 and ground.
    • If less than 4.8 volts, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than 5.2 volts, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Verify the scan tool Engine Oil Pressure Sensor parameter display is greater than 550 kPa (80 psi).
    • If less than 550 kPa (80 psi), test the signal circuit for a short to ground. If the circuit tests normal replace the ECM.
  5. Install a 3-amp fused jumper between the signal circuit terminal 3 and the low reference circuit terminal 1. Verify the scan tool Engine Oil Pressure Sensor parameter display is less than 8 kPa (1.2 psi).
    • If greater than 8 kPa (1.2 psi), test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  6. Ignition ON, command the indicators OFF with the scan tool.
    • If the EOP indicator does not turn OFF, replace the IPC.
  7. If all circuits test normal, replace the EOP sensor.
scientia non olet · About LEMON Manuals