LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Electrical >> Gauges >> Displays And Gages >> Diagnostic Information and Procedures >> DTC P0462 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  2. Ignition ON, verify that the scan tool Fuel Tank Level Remaining parameter display is less than 4 percent.
    • If greater than the specified range, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the ECM.
  3. If all circuits test normal, test or replace the fuel level sensor.
scientia non olet · About LEMON Manuals