LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Vent Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Rear Axle Vent Hose
    GM796010Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose to the vehicle.
    • Route the same way as when removed.
    • Ensure that the hose is free of kinks and is routed clear of sharp objects.
    • Ensure that the vent is not plugged.
  2. Install the vent hose clip (2) to the tab on the filler neck (1).
    3. Fig 2: Rear Axle Vent Hose Clip
    GM796011Courtesy of GENERAL MOTORS CORP.
  3. Install the vent hose clip to the frame.
    4. Fig 3: Rear Axle Vent Hose & Vent Tube
    GM796012Courtesy of GENERAL MOTORS CORP.
  4. Install the vent hose (1) to the vent tube (4).
  5. Install the vent hose (1) to the clip at the top of the rear axle (3).
  6. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals