LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing Axle Shaft Seal & Bearing From Axle Housing Using J 2619-01 & J 44685
    GM913418Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Drain the rear axle lubricant. Refer to Rear Axle Lubricant Replacement .
  4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
  5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
  6. Remove the axle shaft seal and the bearing from the axle housing using the J 2619-01  and the J 44685  . See Special Tools .
scientia non olet · About LEMON Manuals