LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Rear Axle Shaft Seal and/or Bearing Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Installing Axle Shaft Bearing Using J 29709 & J 8092
    GM913423Courtesy of GENERAL MOTORS CORP.
  1. Install the axle shaft bearing using the J 29709  and the J 8092  . See Special Tools .
  2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
    3. Fig 2: Installing Axle Shaft Seal Using J 29713
    GM913424Courtesy of GENERAL MOTORS CORP.
  3. Install the axle shaft seal using the J 29713  . See Special Tools .
  4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  5. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
  6. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Fill the rear axle with lubricant. Refer to Rear Axle Lubricant Replacement .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals