LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Rear Axle Housing Replacement >> Removal Procedure

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear axle assembly. Refer to Rear Axle Replacement .
  3. Remove the rear axle cover housing and gasket. Refer to Rear Axle Housing Cover and Gasket Replacement .
  4. Remove the axle shafts. Refer to Rear Axle Shaft Replacement .
  5. Remove the brake caliper brackets. Refer to Rear Brake Caliper Bracket Replacement .
  6. Remove the axle shaft seals and the axle shaft bearings. Refer to Rear Axle Shaft Seal and/or Bearing Replacement .
  7. Remove the differential assembly. Refer to Drive Pinion and Ring Gear Replacement .
  8. Remove the drive pinion shaft yoke and the seal. Refer to Drive Pinion Flange/Yoke and/or Oil Seal Replacement .
  9. Remove the drive pinion. Refer to Drive Pinion and Ring Gear Replacement .
scientia non olet · About LEMON Manuals