LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Rear Axle Housing Replacement >> Installation Procedure

Installation Procedure

  1. Install the new drive pinion bearing cups into the axle housing. Refer to Drive Pinion Bearings Replacement .
  2. Install the drive pinion. Refer to Drive Pinion and Ring Gear Replacement .
  3. Install the differential assembly. Refer to Drive Pinion and Ring Gear Replacement .
  4. Adjust the backlash. Refer to Backlash Adjustment .
  5. Adjust the differential side bearing preload. Refer to Differential Carrier Bearing Preload Adjustment .
  6. Perform a gear tooth contact pattern check. Refer to Gear Tooth Contact Pattern Inspection .
  7. Install the new axle shaft bearings and the axle shaft seals. Refer to Rear Axle Shaft Seal and/or Bearing Replacement .
  8. Install the brake caliper brackets. Refer to Rear Brake Caliper Bracket Replacement .
  9. Install the axle shafts. Refer to Rear Axle Shaft Replacement .
  10. Install the rear axle housing cover and gasket. Refer to Rear Axle Housing Cover and Gasket Replacement .
  11. Install the rear axle. Refer to Rear Axle Replacement .
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals