LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Rear Axle Housing Cover and Gasket Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Brake Pipe/Harness Bracket & Nut
    GM913428Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Drain the rear axle. Refer to Rear Axle Lubricant Replacement .
  3. Remove the nut and brake pipe/harness bracket from the stud.
    4. Fig 2: Rear Axle Housing Cover & Gasket
    GM913425Courtesy of GENERAL MOTORS CORP.
  4. Note the location of the jounce hose bracket bolt (1) and the brake pipe/harness bracket stud (2) before removal.
  5. Remove the rear axle housing cover bolts (4).

    Discard the rear axle housing cover bolts.

  6. Remove the rear axle housing cover and gasket (3) from the axle housing.
    1. Catch the oil in a drain pan.
    2. Remove any gasket material from the rear axle housing and/or the rear axle housing cover.
scientia non olet · About LEMON Manuals