LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Rear Axle Housing Cover and Gasket Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Rear Axle Housing Cover & Gasket
    GM913425Courtesy of GENERAL MOTORS CORP.
  1. Install the gasket (3) and the rear axle housing cover.
    2. IMPORTANT: Do not reuse the rear axle housing cover bolts.
  2. Install the jounce hose bracket with a new bolt (1) and the new brake pipe/harness bracket stud (2) in their proper locations. Do not tighten.
    3. NOTE: Refer to Fastener Notice .
  3. Install the remaining new rear axle housing cover bolts.

    Tighten:  Tighten all the rear axle housing cover bolts in a crosswise pattern to 40 N.m (30 lb ft).

    4. Fig 2: Brake Pipe/Harness Bracket & Nut
    GM913428Courtesy of GENERAL MOTORS CORP.
  4. Install the brake pipe/harness bracket and nut to the stud.

    Tighten:  Tighten the nut to 40 N.m (30 lb ft).

  5. Fill the rear axle. Refer to Rear Axle Lubricant Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals