LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Electronic Locking Differential Coil Lock Replacement >> Installation Procedure

Installation Procedure

  1. Lubricate the differential bearing assembly, the differential coil assembly and the differential bearing race with axle lubricant. Use the proper fluid. Refer to Fluid and Lubricant Recommendations .
    2. Fig 1: Differential Bearing Race
    GM851633Courtesy of GENERAL MOTORS CORP.
  2. Install the locking differential coil assembly.
  3. Install the differential bearing race.
    4. Fig 2: Differential Bearing Retainer
    GM851631Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The differential bearing race must be compressed in order to install the differential bearing retainer.
  4. Install the differential bearing retainer by performing the following steps:
    1. Install the differential bearing retainer.
    2. With the aid of an assistant, push the differential bearing race down towards the differential case in order to compress the differential bearing retainer and differential coil assembly against the locking differential coil plate.
    3. Install the differential bearing retainer.

      Make sure the differential bearing retainer is evenly and fully seated in the differential bearing retainer slot before releasing the differential bearing race.

  5. Install the differential side bearing. Refer to Differential Side Bearings Replacement .
  6. Install the differential assembly. Refer to Differential Replacement .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals