LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Differential Side Bearings Replacement >> Removal Procedure

Removal Procedure

  1. Remove the differential assembly. Refer to Differential Replacement .
    2. Fig 1: Removing Left Side Differential Side Bearing
    GM856133Courtesy of GENERAL MOTORS CORP.
  2. Remove the left side differential side bearing by performing the following steps:
    1. Install the J 45766  (3), the J 36597  (2), and the J 8433  (1) as shown. See Special Tools .
    2. Mount the J 8433  into a vise. See Special Tools .
    3. Remove the differential side bearing by turning the J 8433-3 clockwise.
    3. Fig 2: Removing Right Side Differential Side Bearing
    GM856137Courtesy of GENERAL MOTORS CORP.
  3. Remove the right side differential side bearing by performing the following steps:
    1. Install the J 45766  (3), the J 36597  (2), and the J 8433  (1) as shown. See Special Tools .
    2. Mount the J 8433  into a vise. See Special Tools .
    3. Remove the differential side bearing by turning the J 8433-3 clockwise.
scientia non olet · About LEMON Manuals