LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Differential Side Bearings Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Driving Differential Side Bearing Into Position
    GM651740Courtesy of GENERAL MOTORS CORP.
  1. Install the differential side bearings by doing the following:
    1. In order to protect the differential case, install the J 36597  in the case on the side opposite the bearing installation.
    2. Install the J 29710  (2) and the J 8092  (1) onto the differential case bearing as shown.
    3. Drive the bearing onto the case using the J 29710  and the J 8092  .
  2. Install the differential assembly. Refer to Differential Replacement .
scientia non olet · About LEMON Manuals