LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Vent Hose Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Vent Hose & Differential Carrier Case Assembly
    GM865993Courtesy of GENERAL MOTORS CORP.
  1. Install the vent hose (1) to the vehicle.
    • Route the vent hose the same way as when removed.
    • Ensure the hose is free of kinks and routes clear of sharp components.
    • Ensure the vent hose is not plugged.
  2. Connect the vent hose (1) to the differential carrier case assembly (2).
  3. Install the vent hose (1) to the wiring bundle.
  4. Install the vent hose to the clip.
  5. Install the front differential carrier shield, if equipped. Refer to Engine Protection Shield Replacement .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals