LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement >> Removal Procedure

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Drain the front drive axle. Refer to Front Axle Lubricant Replacement .
    3. Fig 1: View Of Wheel Drive Shaft Inboard Flange Bolt - Front Drive Axle
    GM763646Courtesy of GENERAL MOTORS CORP.
  3. Remove the right wheel drive shaft inboard flange bolts from the inner axle shaft.
  4. Disconnect the right wheel drive shaft from the inner axle shaft.
    5. Fig 2: Disconnecting Inner Axle Shaft - Front Drive Axle
    GM763648Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the inner axle shaft from the differential case side gear using a hammer and brass drift.
    6. Fig 3: Front Drive Inner Axle Shaft Housing Nuts
    GM763653Courtesy of GENERAL MOTORS CORP.
  6. Remove the inner axle shaft housing nuts from the bracket.
    7. Fig 4: Inner Axle Shaft Housing Bolts - Front Drive Axle
    GM763644Courtesy of GENERAL MOTORS CORP.
  7. Remove the inner axle shaft housing bolts from the differential carrier assembly.
  8. Remove the inner axle shaft and inner axle shaft housing from the vehicle.
  9. Remove the inner axle shaft from the inner axle shaft housing.
  10. Remove the inner axle shaft seal and the bearing from the inner axle shaft housing. Refer to Front Drive Axle Inner Shaft Seal and Inner Shaft Bearing Replacement .
scientia non olet · About LEMON Manuals