LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Front Drive Axle Inner Shaft Seal and Inner Shaft Bearing Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of J 29369-2 & J 2619-01
    GM856114Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Drain the differential carrier assembly. Refer to Front Axle Lubricant Replacement .
  3. If replacing the right side seal, perform the following steps:
    1. Remove the inner axle shaft and housing assembly from the differential carrier case assembly. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement .
    2. Install the inner axle shaft housing into a vise.

      Clamp only on the mounting flange of the inner axle shaft housing.

    3. Install the J 29369-2  behind the inner axle shaft seal. See Special Tools .
    4. Install the J 2619-01  (2) to the J 29369-2  (1). See Special Tools .
    5. Remove the inner axle shaft seal using the J 2619-01  .
    4. Fig 2: Identifying J 29369-02 Behind Inner Axle Shaft Seal
    GM856120Courtesy of GENERAL MOTORS CORP.
  4. If replacing the right side bearing, perform the following steps:
    1. Remove the inner axle shaft and housing assembly from the differential carrier case assembly. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement .
    2. Install the inner axle shaft housing into a vise.

      Clamp only on the mounting flange of the inner axle shaft housing.

    3. Install the J 29369-2  behind the inner axle shaft seal. See Special Tools .
    4. Install the J 2619-01  (2) to the J 29369-2  (1). See Special Tools .
    5. Remove the inner axle shaft seal using the J 2619-01  .
    6. Install the J 29369-2  behind the inner axle shaft bearing. See Special Tools .
    7. Install the J 2619-01  (2) to the J 29369-2  (1). See Special Tools .
    8. Remove the inner axle shaft bearing using the J 2619-01  .
    5. Fig 3: Identifying J 29369-2 Behind Inner Axle Shaft Seal Or Inner Axle Shaft Bearing
    GM868357Courtesy of GENERAL MOTORS CORP.
  5. If replacing the left side seal and/or bearing, perform the following steps:
    1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement .
    2. Place the differential carrier assembly into a vise.

      Clamp only on the mounting flange of the differential carrier assembly case.

    3. Remove the inner axle shaft using a hammer and a brass drift.
    4. Install the J 29369-2  (2) behind the inner axle shaft seal or the inner axle shaft bearing as necessary. See Special Tools .
    5. Install the J 2619-01  (1) to the J 29369-2  (2). See Special Tools .
    6. Remove the inner axle shaft seal and/or the inner axle shaft bearing using the J 2619-01  .
scientia non olet · About LEMON Manuals