LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Front Axle Vent Hose Connector Replacement >> Removal Procedure

Removal Procedure

  1. Raise the vehicle. Refer Lifting and Jacking the Vehicle .
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
    3. Fig 1: Front Drive Axle Vent Hose & Vent Hose Connector
    GM1335147Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the vent hose from the vent hose connector.
    4. Fig 2: Front Drive Axle Vent Hose Connector
    GM1335150Courtesy of GENERAL MOTORS CORP.
  4. Remove the vent hose connector.
scientia non olet · About LEMON Manuals