LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement (Inner Axle Shaft Housing) >> Removal Procedure

Removal Procedure

  1. Remove the inner shaft housing. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement .
  2. Install the inner shaft housing into a vise.
    3. Fig 1: Identifying J 45755-2, J 45755-1, Forcing Screw, Bearing & Washers Over Inner Shaft Housing Bushing
    GM863546Courtesy of GENERAL MOTORS CORP.
  3. Install the J 45755-2 (2), J 45755-1 (1), and the forcing screw, bearing and washers (3) over the inner shaft housing bushing as shown.
  4. Remove the inner shaft housing bushing using the J 45755  . See Special Tools .
scientia non olet · About LEMON Manuals