LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement (Inner Axle Shaft Housing) >> Installation Procedure

Installation Procedure

  1. Install the inner shaft bushing into the inner shaft housing bushing bore.

    Ensure that the inner shaft bushing is positioned so that the bushing is being driven in from the front of the inner shaft housing towards the rear of the inner shaft housing.

    2. Fig 1: Installing J 45755-2, J 45755-1, Forcing Screw, Bearing & Washers Inner Shaft Housing Bushing
    GM863547Courtesy of GENERAL MOTORS CORP.
  2. Install the J 45755-2 (2), J 45755-1 (1), and the forcing screw, bearing and washers (3) over the inner shaft housing bushing as shown.
  3. Press the bushing into the inner shaft housing bore using the J 45755  . See Special Tools .
  4. Remove the inner shaft housing from the vise.
  5. Install the inner shaft housing. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement .
scientia non olet · About LEMON Manuals