LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement (Differential Carrier) >> Removal Procedure

Removal Procedure

  1. Remove the differential carrier assembly. It is not necessary to drain the differential carrier assembly. Seal the vent tube opening with a piece of tape to prevent the axle lubricant from leaking from the differential carrier assembly. Refer to Differential Carrier Assembly Replacement .
    2. Fig 1: Identifying J 45755-3, J 45755-4, Forcing Screw, Bearing & Washers Over Differential Carrier Assembly
    GM863549Courtesy of GENERAL MOTORS CORP.
  2. Install the J 45755-3 (2), J 45755-4 (3), and the forcing screw, bearing and the washers (1) over the differential carrier assembly bushing as shown.
  3. Remove the differential carrier assembly bushing using the J 45755  . See Special Tools .
scientia non olet · About LEMON Manuals