LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement (Differential Carrier) >> Installation Procedure

Installation Procedure

  1. Install the differential carrier assembly bushing into the differential carrier assembly bushing bore.
    2. Fig 1: Installing J 45755-2, J 45755-1, Forcing Screw, Bearing & Washers Over Differential Carrier Assembly Bushing
    GM863551Courtesy of GENERAL MOTORS CORP.
  2. Install the J 45755-2 (2), J 45755-1 (3), and the forcing screw, bearing and washers (1) over the differential carrier assembly bushing as shown.
  3. Press the bushing into the differential carrier assembly bushing bore using the J 45755  . See Special Tools .
  4. Install the differential carrier assembly. Once the differential carrier assembly is installed, remove the piece of tape in order to connect the vent hose. Refer to Differential Carrier Assembly Replacement .
scientia non olet · About LEMON Manuals