LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System With TCS & VSES >> Repair Instructions >> Brake Pressure Modulator Valve Replacement >> Removal Procedure

Removal Procedure

CAUTION: Refer to Brake Fluid Irritant Caution .
    Fig 1: Identifying Brake Master Cylinder And Power Brake Booster Assembly
    GM1977780Courtesy of GENERAL MOTORS CORP.
  1. Remove the brake master cylinder and power brake booster assembly. Refer to Brake Master Cylinder with Power Brake Booster and Chassis Control Module Replacement .
  2. Install the CH-47830  (1) to the master cylinder assembly. See Special Tools .
  3. Position the CH-47830  with the master cylinder assembly in a vise. See Special Tools .
    4. Fig 2: Identifying Master Cylinder Reservoir
    GM1977792Courtesy of GENERAL MOTORS CORP.
  4. Remove the master cylinder reservoir (1). Refer to Master Cylinder Reservoir Replacement .
    5. Fig 3: Power Brake Booster
    GM1977787Courtesy of GENERAL MOTORS CORP.
  5. Remove the power brake booster (1). Refer to Power Brake Booster Replacement .
    6. Fig 4: Identifying Brake Pressure Modulator Valve (BPMV)
    GM1977793Courtesy of GENERAL MOTORS CORP.
  6. Remove the brake pressure modulator valve (BPMV) (1) bolts.
    7. Fig 5: BPMV Gasket
    GM1977794Courtesy of GENERAL MOTORS CORP.
  7. Remove the BPMV gasket (1) and the BPMV module assembly (2).

    Discard the BPMV gasket.

    8. Fig 6: View Of Brake Fluid Level Sensor Bracket Bolt And Bracket
    GM1977736Courtesy of GENERAL MOTORS CORP.
  8. Remove the brake fluid level sensor bracket bolt (1) and bracket (2) from the BPMV module assembly.
scientia non olet · About LEMON Manuals