LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Park Brake >> Repair Instructions >> Parking Brake Release Handle Assembly Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Refer to BATTERY DISCONNECT CAUTION .
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
    2. Fig 1: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
  2. Remove the park brake release lever mounting bolt.
  3. Remove the park brake release lever handle from the knee bolster.
  4. Remove the MID-Bussed Electrical Center from the bracket.
  5. Remove the park brake release cable housing from the pedal assembly.
  6. Remove the park brake release cable from the pedal assembly.
  7. Note the routing of the cable as you remove the park brake release handle assembly from the vehicle.
scientia non olet · About LEMON Manuals